[email protected] Need Help? Call us on: 0131 663 3377

Little Bee 30A Pro 4 in 1 Mini ESC

Special Price £29.99 Regular Price £49.99
In stock
Little Bee 30A Pro 4 in 1 Mini ESC
Little Bee 30A Pro 4 in 1 Mini ESC is available to buy in increments of 1

Little Bee 30A Pro 4 in 1 Mini ESC

 BLHeli OneShot125 

2-6 CELL

These new PRO ESC's use the SILABS F396 MCU which runs at 48MHz, which is much faster than on the original Little Bee 30A ESC, which means that the new Little Bee 30A Pro ESC will provide a faster and crisper response. So now you can get those sought-after low looptimes. The 30A Pro version also have better support for those high KV motors, eliminating any desync problems.

These are flashed with BLHeli and OneShot enabled and with damped mode the throttle response and changes are incredible.
Using Silabs processor and a super fast dedicated chip make these able to freewheel and brake with ease.
Sometimes size isnt everything and its certainly the case with the LittleBee Esc, Weighing in at a mere 5g (with cables) and only 25mm x 12mm .
Factory flashed with BLHeli this firmware unleashes the full performance of these escs.
Oneshot enabled this is a feature that again is used by all the top FPV Drone racers throughout the world.
Easily Upgradeable with a programmer which is available seperate allows all the features and settings to be tweaked to your liking such as enable oneshot, Reverse motor and Dampning. A programmer is recommended for the more serious racer however the default settings out the box are good to go. 

These tiny ESCs have all the performance you would hope for, You'll struggle to find a frame small enough to fit these ESCs and they'll still give you plenty of headroom on a standard 250 size quad!

Don't forget - these ESCs have to BEC so you will still need a 5V power source for your flight controller, receiver, etc. Have a look at the related items below for suitable a suitable PDB and BEC. You may also need bullet connectors unless you intend to solder your motors direct to the ESCs.


- Input: 2-6s Lipo
- Version: Pro Version with F396MCU
2-6S support with 30A continuous load and 35A peak (10 seconds)
- PCB - 4 Layer Blind Pole PCB - 3oz Pour
- Mosfet: N-Channel
- BEC: None "Opto"

More Information
Is Featured No
Private Event Use Category Settings
Private Event Landing Page Login Page
Write Your Own Review
You're reviewing:Little Bee 30A Pro 4 in 1 Mini ESC
Your Rating